SuperScript Version 3.xx has been updated to support FSUIPC Ver.
You should then have your throttle quadrant set up and you can repeat for conditon, propeller, mixture levers at any time. This is the third major release of SuperScript. You then pull the throttle into the detent and push it out of the detent onto the "shoulder" where you would set the range where it comes out of idle and press "Set" then repeat going the other way down towards reverse and when the lever is on the "shoulder" once again press set. The problem is between mobiflight and fsuipc. To test if button is working, I changed the key to 'A' and open text file then pressed button and it wrote 'A'. with virtual buttons) - Further controls added from 0.9.0. Dit opstarten wordt geregeld in een exe.xml die in de map C:\Users\jouwnaam\AppData\Roaming\Microsoft Flight Simulator\ aanwezig is. fix bug in key assignments to allow assignment to numpad keys with numlock off (PgDn, End, etc) - Correction to registry scanning that caused a crash when a non-existant device found - initial button delay now working, and improvements for a more accurate repeat rate (esp. Dit ini-bestand wordt gemaakt wanneer FSUIPC7.exe voor de eerste keer opstart. Je mist in dit rijtje nog een FSUIPCF.ini bestand. But when I press the button it doesnt toggle. De FSUIPC7.key is nodig voor volledige functionaliteit.
Then in mobiflight I added button and chose emulate key action. Then you press set (or resest) on the left and pull your throttle below the detent -16385 (ish) and press "Set" for reverse then push the throttle lever to the max 16385 and press set for max. I assigned 'F3' to run this lua file and it works. Second option - The second method is by repeating the first section using FSUIPC "Axis Assignment" you would set "Send direct to FSUIPC calibration" under that select "Throttle." Then go to the Joystick Calibration tab and set up (I think it works) Throttle 1. Using FSUIPC "Axis Assignment" you would set "Send direct to FSUIPC calibration" under that select "Throttle."įirst Option - You then have a choice to add thrust reverse on the same tab over on the right if the area under the detent reads as a button and tick off the first "Control sent when range entered" and enter "Throttle Decr" then tick off "Control to repeat whilst in range" then tick the second "Control sent when range entered" and enter "Throttle cut."
0 kommentar(er)
